Hello, I use lightburn for a laser cutter 40w firmware Marlin card ramps 1.4, my problem is that the movement between two pieces and very slow, about 10mm / s despite a setting at 500mm / s. The faster I cut, the faster it moves … do you have an idea to help me? thank you in advance

Have a look at this previous post found using the forum search: [image] Travel speed and cutting/engraving Getting Started With LightBurn Hi, I want to set a higher speed for travel movements and lower speed for cutting/engraving, but I can’t find where to set the travel…

Marlin doesn’t interpret G0 and G1 moves differently, so you have to use the “Fast Whitespace Scan” device setting to change the movement speed for G0 moves. [image]

OK. Cela fonctionne parfaitement. Merci beaucoup

Problem feedrat

LightBurn Software Questions

Rick (Technical Evangelist) May 21, 2019, 6:43pm 2

Have a look at this previous post found using the forum search: