Problem with gaps between fingers

[jkwilborn (Jack Wilborn)]

I generate them with no application of kerf in the application and apply it in Lightburn.

This way I’m not adjusting it, then overriding the adjustment to correct it…

Did you figure out your kerf? A good value is 1/2 the kerf.

Kerf Offset test: with built-in vernier scale for accuracy, no tools required!

There has been a bit of a flurry of marquetry lately on the forum, and it prompted me to make a tool to help calculate kerf offset accurately and easily, while using minimal material: [image] I was inspired by @jkwilborn’s tool, but I added a vernier scale to make it easier to measure, without needing calipers! Just cut it, slide it, and calculate your kerf. [Preview of the kerf offset tool in LightBurn.] Here’s the file: Kerf Test with Vernier Scale.lbrn2 (2.4 MB) I’d love any feedbac…

Good luck