Rallumage du après "suspendre" et "reprendre" (Restart of after "suspend" and "resume"))

LightBurn Hardware Compatibility Ortur Lasers
1

Comment rallumer le laser avec la commande “reprendre” ?

How do I turn the laser back on with the “resume” command?

2

It may depend on the command that suspended the engraver.

When connected to the laser engraver Please type the following request into the Console window in LightBurn:
$i
then press enter.

Please Select and copy that text and paste it into a reply here.

This will provide the precise model name and firmware revision number of your laser engraver. I can’t say for certain what the command is or if it’s ‘real-time’. Hopefully the Ortur here is grblHAL based and follows the ! hold and ~ cycle start.

More about those commands here:

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.