Can you have Rdworks AND Lightburn software both running on the same computer?
And connected to the same laser. OMtech 60w?
There is a project function needed via RDworks that is not available in Lightburn.i.e. The “Dot” perforation.
Can you have Rdworks AND Lightburn software both running on the same computer?
And connected to the same laser. OMtech 60w?
There is a project function needed via RDworks that is not available in Lightburn.i.e. The “Dot” perforation.
There is a perforation mode in the cut/layer, which I understand you can use instead.
Probably. The issue is that the Ruida will respond to whomever sends it a UDP packet…
Thanks. What I need is a true “dot” perforation and not a “dash” as in Lightburn.
something that produces a line with a kind of pulse, pulse, pulse, etc. instead of actually stopping between each burn. RDWorks has the “dot” availability.
There is a way to do that, I’m unable to find the thread.
it would have to stop to punch a hole…
I’m sure I’ve see it described.
There is a ‘dot mode’ in the advanced section…
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.