Real Time z-axel offset

[Zetaz (Zeta zetterberg)]

is it possible to adjust the z-offset in real time. if you have an uneven surface to engrave on.

[ednisley]

@Zetaz

is it possible to adjust the z-offset in real time

The short answer is “No”.

A much longer discussion:

Z axis tracking the work surface

Hi, and hoping some one with some with a lot more knowledge on electronics can point me in the right direction. The industrial laser I used to work with mainly cutting steel plates, used a Precitec system, not sure of the sensor type it used. Having a conductive Nozzle on my laser i was hoping to even if this is not used as the sensor find a way of tracking the work surface accurately, I have asked a few people they say it uses Dopler Radar, Inductive, Lidar and a a couple of other methods, i…