Rotary (for Galvo) completed times not shown

[jkwilborn (Jack Wilborn)]

I’m confused about speeds also… Posted it in these posts…

Scan rate can't be increased

I have my scan speeds set to around 300mm/s when testing the galvo when I assembled it yesterday. I have bumped it up to 1500mm/s and it doesn’t look any faster. The preview is supposed to take 30 some seconds and takes 8 minutes… I have looked for a limit value for X or Y but there doesn’t seem to be one… Framing is set to 4000mm/s and I don’t think it’s running that fast either. Any suggestions on how to speed up the scan…?

Mirror anglular velocity adjustment for different lenses

I have setup my laser for my 300x300mm coverage and have used the 2,000mm/s speeds… I have two more lenses coming that are far shorter… I’ve assumed the 2,000mm/s was being applied to the material … probably erroneously… If I change the height of the galvo head, it will change how fast the surface speed is on the material. If at the A height, it’s laying down 2000mm/s, it has to engraving faster at the B height with the same settings. Is this adjustable based on lens size? [scan-speed-adj…

Don’t know what to tell you…