Rotary Set Up Issues 2.0.02

[jkwilborn (Jack Wilborn)]

@robertguyton

trying to control the rotary from lightburn in the rotary set up screen, it is not responding properly … When I use the touch screen on the laser to move the head, it responds perfectly on both the x axis and y axis (rotary)

If it responds from the machines console it’s likely OK. Does it move the distance specified by the controller?

Check this setup for a rotary and let us know where you have issues.

A rotary attachment question. Warning: Newb

Configuring for a rotary should not be an issue. I’m assuming you are using the Y axes… you didn’t say… find steps/rotation a. identify the switch settings b. translate from the motor driver placard steps/rotation is then computed based on a ratio. a. value entered is steps/rotation multiplied by the ratio which results in the steps/rotation of the wheel, which is what Lightburn needs to know. This is the basic procedure. [motor-driver-switches] Look up the settings on the devices pla…

If you have issues, sing out.