Rotary won't run a full wrap file, stops after a couple inches

I have been running cups all weekend, with just a logo in the middle of the cup, on my rotary. I plugged in a full wrap file, and it won’t run the whole file. It gets about 1/4 of the wrap run and stops. No problem running a regular cut/engrave file without the rotary, and my steps per rotation are calibrated and the design is cutting the way it is supposed to.

I assume this is an EZCad2 board?

I had a similar issue, but forgot to set something… I think it’s in this thread…

If you still have issues, sing out…


1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.