Run Gcode don´t work

[derJoe (Sepp)]

Dear Community,

through my problem engraving big pictures

Offset between engraving and cuting

Dear Community, Yesterday I lasered with my X20 Pro a very large image (645x360mm) for the first time. The image is offset by about 6mm to 600mm! I have been able to isolate the problem, what is not a mechanical problem. If I cut the outline DIRECT after engraving, without homing between, the cutting line is still the correct one. ** [IMG_6423] [IMG_6424] ** Lightburn produce an incremental gcode for engraving. So the offset by line must be app. 0.001mm. It can only be either a firmwar…

I come to the idea to edit the gc code a bit (add to every Y movement a X-0.001)
but engraving wont start (LB1.5.02).
If I save it and then try to start without editing; the same…
Now I run a test with LaserGRBL, but I don´t use Lightburn to switch then to another software

Josef