Same cut settings in RDworks wont cut in Lightburn

LightBurn Software Questions
1

Simple text file created in RDworks to cut at 8/75 cuts fine. No Problems. Same simple text file created in Lightburn with same 8/75 set to Line, doesnt even mark the wood. What am I doing wrong? My controller label is RDC6442S-B(EC). Lightburn finds and uses Ruida 644XS

2

Same settings, including Min Power? That’s the one everyone misses when they post this. :slight_smile:

3

That was it… Thanks!

4

A post was split to a new topic: Ruida Power Low

5

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.