Seeking advice on replacing the controller of a JQ1390 CO2 (LNC-LS240A controller) laser with one compatible with Lightburn

[jkwilborn (Jack Wilborn)]

A slightly different controller, but it should be relatively easy to swap them out.

Setting up the controllers configuration might be a bit more time consuming.

Replacing a LNC LS232A controller with a Ruida 6445, will the configuration be an issue?

I’ve a 1290 machine with an LNC controller that’s had issues connecting with LB. I haven’t been able to sort the issues (despite some suggestions in a previous post), now, with this Covid 19 crisis, I thought it would be a good time to change the controller when the machine isn’t in use. It was the long term plan This forum has answered some of my questions, however, my main concern is setting up the new controller with the right configuration. I’ve contacted the original machine manufacturer (…