Selective filling?

Hi all,

I have a logo that I wanted to laser engrave. The logo is imported from Adobe Illustrator to Lightburn, as can be seen below. Selecting the ‘Mode’ to ‘Fill’ and previewing it shows almost the complete logo filled. I want only the shapes to be filled in. Is there a way to select which object is to be filled within Lightburn, or should I make some modification in Adobe Illustrator? Also, previewing with the ‘Mode’ on ‘Line’ it shows only the lines as expected.

Thanks in advance for any help.


Looks like that is what you have achieved. All shapes are filled, but I think I understand what you are trying to accomplish. You will need to adjust the artwork to define where the fill starts and stops. LightBurn has a very specific way of defining this, which you need to apply to get the results you are looking for.

Start with this post to help you better understand how LightBurn uses boundaries to define Fill behavior.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.