Hello, I noticed on a recent project I had small areas that did not cut all the way through. I had done a 1 by 1 inch test cut of this material with no issues. it almost seems like a stop and start point.

If moving the head caused the power drop, you might need to align your mirrors - Try running a square a little smaller than the size of the bed on a piece of cardboard, with min and max power both set the same, but just high enough to make a mark. If the power isn’t even across the machine, you nee…

Small Non Cut Areas

LightBurn Software Questions

Rick (Technical Evangelist) December 8, 2019, 5:36pm 2