Snapmaker Ray - no crosshairs when framing

[berainlb (PY)]

Take a look at this post. The OP didn’t have luck with this but you may fare better:

Webcam Kalibrierung geht nicht, Overlay funtioniert nicht (Camera calibration doesn't work, overlay doesn't work)

Try this: Shutdown LightBurn Open Task Manager and make sure no LightBurn tasks are running Start LightBurn Make sure the right device profile is selected in Laser window. Then complete camera alignment. Once completed, restart LightBurn Check Overlay What are the results? For the Red Crosshair I found these results with a search: For the Artisan use the following; Crosshair On; M2000 L13 P1 Crosshair Off; M2000 L13 P0 For the Snapmaker use the following; Crosshair On: M2002 T3 P1 Cro…