I’m looking back at a separate topic with a Snapmaker Ray. I’m not sure what’s going on but it seems like these machines are not getting shipped with the proper configuration or it’s not clear how they’re meant to work.
The conclusion in that Topic was that machine homed top-left with origin at bottom-left. In order to accommodate this a work offset was applied.
Let’s reproduce that.
Can you run these commands in Console:
G10 L2 P1 X0Y-400
$10=0
Then home the machine. Test jogging controls to make sure they work correctly. Then run a job to make sure that things are oriented correctly.
Test the laser positioning to make sure that’s working correctly.