Strange message on screen

[Rick (Technical Evangelist)]

Frame Slop Error frustration

The frame and orange lettering, even though you aren’t sending them to the laser, are being considered for framing and sizing. The controller is telling you that part of the job might be out of the cutting area, but you should be able to just hit Enter on the controller and it will do whatever part it can that is still within the bounds (in your case, all the cuts should be).

Frame slop question?

Press Ctrl+Shift+A (see everything) and then Ctrl+A (select everything). Often you’ll find you have a stray line somewhere outside the visible part of the workspace. You can also flip temporarily to ‘User Origin’ and then change the job origin to the 4 corners to make sure the green square goes where you think it should. With what you’re showing here, the bounds from selecting everything or showing the green dot should be within your page boundary by a couple mm at least. If it’s not, you ha…