Thin Shapes Vey Close to each other

[parsec (FerAS)]

Sorry to step in.
Exactly what happened to me with a diode laser and I came up with the below solution.
Don´t now if your cuts repeated 6 times each segment but instead of 6 passes use 6 cloned sublayers.

Lightburn Super Trick

Hello to all. Instead of making multi-pass cuts in intricate details where laser burns the same segment over and over again and that sometimes leads to material burn… You can automatically make 1 pass cut plus 1 pass cut plus 1 pass cut and so on to let material cool a bit. Using Lightburn sub-layers like in the enclosed example. It take a few seconds more but gives much better results. At the end of the job start the job again (3 times in this case) or use cut job with 9 cloned sub-layers, …