Trocen TL-A1 - Missing option to activate Z Height in device settings

[Matz]

Hello,
I connected my CO2 Laser with TL-A1 controller succesfull and can start laser jobs, but there are no options to activate Z Height and Autolevel in my lightburn device settings. Can you help me to fix this?
The table is driven and the probe for the height is active when touching something.

Thank you in advance!

[gilaraujo (Gil Araújo)]

Hi Matz

This might be relevant

AWC 708C Lite Enable Z-Axis option is missing from Device Settings

Here is a small historical collection of responses from Oz on this subject. Aug '19 LightBurn: As far as I know, Trocen controllers do not have the ability to alter the Z axis during a cut. I have found nothing in LaserCAD that will do this, so I have sent a message to Trocen to ask if this is even possible, and if so, if they will share the commands with me to do so. Followed by: Trocen has responded - there is no way to do this with their hardware. Dec '19 LightBurn: Trocen gives m…

[jkwilborn (Jack Wilborn)]

I think that’s one of the disadvantages of non Ruida control systems… little idiosyncrasies between operations.

Good reason to ask the vendor for the requested Ruida…

Good luck