Trying to make rotary start on one side and end on the opposite

Doing a couple glasses today and noticed for the first time that the rotary will rotate and “jump around” to different parts of the glass to engrave. Normally it would start on one side and finish on the other. Now because it jumps from different parts of the glass, there are some imperfections in the glass. Played with the optimization settings and did a few dry runs with the laser off but it doesn’t change anything. Any help or advice is appreciated

Got it sorted out. Under Advanced Settings have to turn off “Flood Fill”

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.