Ultimate Air Assist and Exhaust Fan

[Jack-here (John Kelvington)]

Have you solved your time delay problem yet?

[jkwilborn (Jack Wilborn)]

I think he used this …

End delay past 60 seconds? Bug?

I noticed the end delay can be set to 60secs, which is great, however, when timing it, it waits for about 17 seconds then finishes the cut. I can’t set it longer than 60secs, so its always waiting about 17 seconds afterwards. I’d like to set it much longer, about 1:30/2 minutes, so that I’m sure the smoke is cleared out of the laser each time.

[StevenM (Steven Marston)]

Yes, I used a solid state relay triggered from the status pin plus the delay function built in LightBurn.