Undefined feed rate error -Smoothieware Setup

[LightBurn (Oz)]

How are you SENDING the fire command? LightBurn has a ‘Fire’ button that sends the correct command, and that’s what I assumed you were using here.

How do I turn on my diode at low power to focus it or frame a job?

Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you have a CO2 laser, as the beam is invisible and this could blind you or start a fire) In LightBurn, go to Edit > Device Settings, or click here: [image] Turn on the ‘Enable Laser Fire Button’ switch (make it green): [image] Quit LightBurn and re-run it. You will now have two new controls in the Move window. A …