When is the update going to happen to get rid of the triangle cutting instead if the square? I can ungroup and then cut the square out does it correctly but when i add engraving to the mix it cuts the triangle insteadnof a square

I don’t see a device button just a devise settings

Device button is on the Laser Panel the same that has the START button

Well does cut the squares but messes up the actual project size

Hi Tim, Could you explain a bit further your problems And/or share screenshots/project LBRN so we can fully understand the issues?

It changed the size of the project I’ve been ![image|375x500 working on to this the middle slot is suppose to be 5mm [image] ![image|375x500] (upload://gEqbLB8458M3lpbHgLui32vfI8c.jpeg) This is what I’m supposed to be Here’s another job messed up It frames out like it’s suppose fit but this…

[image] Here’s another issue it frames out like it’s will fit but it messed up

![image|375x500](upload://hGgt4j3ilWVku152KJWHCc4g8G6.jpeg Itnonly printed half of it due to the size being wrong I’ve tried to download 6.0 again and also went back to 5.3 and still does the same thing How do I get this to work correctly

Will it show 1.7 on top of the screen

Update for the xtool S1

LightBurn Software Questions

gilaraujo (Gil Araújo) May 6, 2024, 8:57pm 2

Hi Tim.

Currently the team is working on a 1.7 version that addresses specifically Xtool S1.
The Beta is public so you can give it a try and also report any issues you might find.

All feedback is good as not many people own S1s and use Lightburn yet