Upgrading Air Assist

[jkwilborn (Jack Wilborn)]

@dalek

status to activate

Status becomes active when you press start or anything that causes the machine to execute the layer.

I’d expect 24V measured from status to 24V… It sounds like the other outputs work…

I don’t know of any configuration settings for the status output… only wind…

Stack Lights on a Ruida 6442G

A while back I posted this concerning outputs 1 & 2 on the Ruida RDC6442G controller. On the RDC6442G, output 1 turns on after the machine has homed and returns to its starting point. It is almost the inverse of the status output, but not quite. As soon as a job starts output 1 turns off (status turns on). If the job is paused, the output 1 turns on (status stays on). When the job is continued output 1 turns off (status stays on). When the job completes output 1 turns on and status turns off. …