Urgent help needed! Replacing M2 Nano board with a MKS DLC32

[gibawatts (Gilberto Almeida)]

Latest update: the laser works!

Thanks to this post

How does this wiring setup look for K40 + MKS DLC32 2.1

Hello, I recently picked up an MKS DLC32 2.1 board to replace the stock board in my K40 laser. I purchased the laser a week ago or so but wasn’t enjoying the Meerk40t work around (cool project though) I’ve removed the digital power control panel and opted to use the touch screen interface with the MKS board. It has a built in test/fire button and I can use my amp meter + set the PSU pot to limit output to the laser so I don’t overdrive it. Below is how I’ve wired the board. It’s working fine…

I just need to calibrate the laser now!