Z for Fiber Galvo Systems

[jkwilborn (Jack Wilborn)]

@carltonlovejoy

EZCad2 software, the unit runs the rotary fine and the Z , so what must i do

I’d guess you’d need to run EZCad2 instead of Lightburn…

---

Is this different than your other post? It seemed to have been pretty hashed out in your previous thread.

Rotary not responding

Have the highly common drivers typical on Fiber Galvo systems for Z and Rotary. This JPT-C-80 form JCZ. The rotary is energized, yes , both coils about 1.2ohm good… but no commanded movement. In the Lightburn window Rotary Set Up, where Rotary is ENABLED there is a Test button at the bottom. When I press it, nothing happens, it stays blue` and nothing is reported below it. The rotary unit/function is new/unused/unapplied. What is the next step in troubleshooting ? Of course, Laser Everything and…

---

When support advises you Z axes operation are not supported … what are you after?