I read that the Lightburn software cant auto dect snapmaker a350

Fantastic. Was a bit touch and go for a while there.

You need to add manually correct

That looks like the state of the art - currently. This may help: [image] Plugged into Snapmaker a350 USB - nothing happens Common Problems Hi folks, new Snapmnaker, firmware up to date. Tried auto-detect on installation of Lightburn - didnt find anything. So set up manual…

Not familiar with MAC just PC/Windows, but you need to set your COM port number and baud rate in Lightburn to match the port number and speed on your mac. this link might help: [image] A newbie confused connecting SnapMaker 2 to my Mac Snapmaker have read some good reviews…

[IMG_0064] [IMG_0065] [IMG_0066] [IMG_0067]

[IMG_0068] [IMG_0069] [IMG_0070]

LightBurn Bridge only works with Ruida controllers. I believe the only available interface for Snapmaker is USB.

how do i change the ip address on my snap-maker to be the same as the light-burn bridge

I’m not following what you’re trying to do. LightBurn Bridge does not work with Snapmaker. Are you attempting something else?

i have that set up but still wont find my laser

Auto find device

LightBurn Hardware Compatibility Snapmaker

JohnJohn (John Johnson) May 9, 2022, 8:40pm 3

That looks like the state of the art - currently.

This may help: