Choppy engraving

[ednisley]

@LiquidSchwartz

why, and how to predict and prevent it

With a Ruida controller, the most likely suspect is problems with the USB connection. If that’s what you’re using, then using Ethernet will immediately solve the problem.

Some discussions:

Random Letters Missing During Laser Cut – Only Works Fine One Letter at a Time

Hi everyone, I’m having a strange issue with my laser cutter and I’d love some help figuring it out. As you can see in the picture (from top to bottom, it shows my first to most recent attempts), some letters are randomly missing or partially cut when engraving text. I’m cutting at speed 50mm/s and power 35%. I’ve already tried applying an offset, and then used the Pathfinder tool (unite/merge) afterward — but there’s always a small issue somewhere. What’s odd is that if I cut each letter in…

Laser stops running after a few seconds

Hello. I’m new to the forum but have been using my OMTech 70W Co2 laser for a couple years. I’m wondering if anyone else has had an issue with the laser stopping after a few seconds. I was running a batch of stuff and as soon as I changed files, Lightburn said it needed to be updated (to version 2.0.02). I did the update and that was it. Every time I try to engrave, it stops after a few seconds. Nothing else changed except for the update. I’ve reinstalled old versions, rebooted everything, and n…

Laser jumps and does not cut the image on the cut line

I am operating macOS Sequoia 15.5 on Apple M1 system. After installing v2.0.00 and trying to cut the laser will jump and cut a line that does not exist on the workspace? I tried multiple times to cut different images and the same occurs each time. I did the update and the same issue. I have reverted back to 1.7.08 and no issues. Any suggestions would be appreciated, [IMG_8505]

Plugging the Ruida controller into the local network, rather than directly into the PC, requires some care to prevent the router from assigning another device to the controllers static IP address. This discussion covers some of the problems and a big-hammer solution:

Hello fellow laser wizards

HELLO, I have a tech problem. My Omtech AF2028 stopped communicating via ethernet. I replaced the cable and still having message, Data not transferred, controller busy or paused. checked IP Adress and replace cable USB connection works fine my modem and hub is fine suggestions are seriously appreciated Bob

If you’re already using Ethernet, then other possibilities come into play, but try the easy solution first.