Hello there, I have the Ortur Laser Master 2 (20w ) since yesterday. I did a couple of tests with Lightburn.
All was working perfectly.
Then my laser stopped halfway through one of my engravings with the message “(MGS restoring spindle)”. Then the problem happened again.
Now I can’t change the power of my laser when I focus, the laser burns the wood directly even if I change the power to 0.25.
If I don’t use the laser focus and burn directly, the laser burns at full power, even if I set a very very low max power. Impossible to have shades for photos, the engraving is only “black”.
More infos of my console:
I hope you can bring me help and all things will be solved. Thanks !