Lightburn MOVE tab, X going in opposite direction

[ednisley]

@LightBurn

Can you share what it was that you changed?

For reference, we did a cold-reconfigure of the XY axes:

Problems with my Ruida controller after trying my new rotary

I am having problems with my Ruida controller on my Red Sail 80 watt CO2 laser. It had been working fine just a couple of weeks ago when I last used it. However this might be a big clue: I was trying to set up my new chuck rotary and could never get it to work correctly as the “X” travel seemed to have a mind of its own and always travelled to the far left even though it was not programmed to do so. A few details about my laser: It is a Chinese 80 watt CO2 with Ruida controller. My working are…

It’s highly like the origin is now in the wrong corner, because Homing was pretty much wrecked.