Losing alignment when traveling, can't make acceleration change write to hardware, xTool D1

[aaroninalaska]

So far so good with new firmware, will keep updating thread. I downloaded new version of Laserbox Basic to upgrade firmware on xTool D1 on 1/22/2022

@aaroninalaska

Testing with new firmware today (v40, will add full # later)
So far so good.
I have burned 4 grids so far, and have not lost alignment. That didn’t happen with old firmware

My first 2 burns of a test grid I had “lead in / lead” out turned off, but it added a lead out line anyway. I turned it on at 0 length, only on one layer.
It appears to have resolved the setting globally, will update after more testing.