Testing with new firmware today (v40, will add full # later)
So far so good. [edit: Not good at all, new problems]
I have burned 4 grids so far, and have not lost alignment. That didn’t happen with old firmware
[EDIT: I was wrong, lead out on cuts always happening. this could be an issue…] My first 2 burns of a test grid I had “lead in / lead” out turned off, but it added a lead out line anyway. I turned it on at 0 length, only on one layer.
It appears to have resolved the setting globally, will update after more testing.
It is also not over scanning now, so the edges get burned strangely. Can’t seem to force this, let me know if anyone knows how.