Losing or gaining steps

[effinsyv (Mike)]

I was chasing a similar issue on my cutter for a long time and I think I’ve finally solved it by changing the PWM setting in vendor settings. If you change anything there, be sure to save a copy locally before you make any changes. This might help

Engraving Alignment and origin issue

Hi all, I’m not sure if this is a hardware or software issue, but I’ve seen this on both RD Works and Lightburn, so my guess is hardware (or a controller setting). I have an issue when cutting shapes (ornaments in this case), where I’m doing a long-ish engraving of multiple ornaments, then I do a cutout of the ornaments. Many times, some of the ornaments are not aligned properly (engraving to cut). I’ve also seen this with the cut and fill function. Tonight, I did some tests to see if i can n…