Monport GM Galvo stays in “framing” and is never ready

LightBurn Hardware Compatibility Galvo
1

Bonjour, je vient de recevoir un Monport Gpro 60w, je n’arrive pas à le configurer, le laser reste en “framing” et n’est jamais ready. pouvez vous m’aider ?

Hello, I just received a Monport Gpro 60w, I can’t configure it, the laser stays in “framing” and is never ready. Can you help me?

2

I’m going to split our posts into a new thread in an attempt to surface these behaviors separately.

In order to help, I’m going to need more information.

  • When following the steps in the manual where does your experience diverge from what is expected?

In order to begin, I need to confirm that the driver was swapped correctly and that communication has been established.

Here’s the link to the Monport Manual that was posted on the thread this was split from.

The following may also be helpful.