Ortur LM2 Pro - doesn't turn off after project / between cuts

[LaserWillie (Willy)]

Laser burns too hot on test fire and stays on after project is done

Hi, Total newbie here and not sure what category this should go under. but my issue is that the laser comes on way too hot and before its supposed to, as well as stays on after the project is done, burning a line across the piece and scrap baseboard. It also comes on way to hot when I do a test fire. I have it set to 1% for the test fire framing function and its burnt a hole through a 1/4" piece of plywood. It also doesn’t turn off when the firing is done for approx. 10-15 seconds, unless i pul…

Could be a bad motherboard.

@OrturTech