Physical framing vs overlay is off

New Laser owner and recently installed (4k-w) camera on Boss LS1630 and having issue with with my laser framing off by aprox 5 cm (North always) along the Y axis of where the overlay placement says it is. The x axis frames in correct location and dimensions. I will add that my gantry does not reach same end point on lower axis as on the top of axis by aprox 1.5 cm. determined by beam stop point on centered honeycomb. Besides correct location of overlay issues I have no difficulty with laser, software or camera.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.