New Laser owner and recently installed (4k-w) camera on Boss LS1630 and having issue with with my laser framing off by aprox 5 cm (North always) along the Y axis of where the overlay placement says it is. The x axis frames in correct location and dimensions. I will add that my gantry does not reach …

[image] Camera Not Aligning Up and Down Cameras Hello Everyone: I’m running into an issue where when I do the alignment test with the 4 circles and put the cross-hairs right in the middle, it’s not aligning properly up and down (North and South). When I did the first alig…

Physical framing vs overlay is off

LightBurn Hardware Compatibility Cameras

Rick (Technical Evangelist) February 18, 2021, 1:40am 2