Problem with printout of large amount of Grouped objects

LightBurn Hardware Compatibility Ruida controllers
5

This may be one of those perverse cases where everything is correct and the controller is screwing up due to an overstuffed memory or communication problems.

Things to do:

  • Delete all the files stored in the controller
  • Use Send to put the entire file in the controller
  • Select the file and start it using the controller console

If that behaves correctly, then it was likely an overstuffed memory.

If it misbehaves the same way every time you run the saved job from the controller, then it’s likely the file was corrupted in transit from LightBurn to the controller.

If it misbehaves differently each time, then something else is wrong.

Is the controller connected over USB or Ethernet?

If USB, switching to Ethernet will eliminate most of the communication problems.

Note that you must ensure the network router cannot assign the same IP address to a different device. These threads may be helpful:

1 Like