Program continually says it is out of range and will not run

[Bonjour (Bo)]

This subject comes up all the time.

Have a look here:

Alarm 2 G-code motion target exceeds machine travel

This is a screen shot of the Move panel. Seems the distance option is not activated. [Screen Shot 2020-12-31 at 9.59.08 AM]

ALARM:2 message

this is the error I’m getting after installing 0.9.21. Any sugestions? Stream completed in 0:00 Starting stream Layer Mandala ALARM:2 G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection) On or near line 5: Job halted Stream completed in 0:00 [MSG:Reset to continue] ok Ortur Laser Master 2 Ready! OLF 139. Grbl 1.1h [’$’ for help] [MSG:’$H’|’$X’ to unlock] [MSG:Caution: Unlock…