Restart at stop point when connection lost?

[Rick (Technical Evangelist)]

@DWH

Ortur 2 keeps disconnecting

You may want to look into this,

ORTUR LASER MASTER 2 - Service Notice - Grounding

ORTUR LASER MASTER 2 - Service Notice - Grounding Full Documentation: http://ortur.tech/orturgrounding Some users have been reporting and experiencing Static Electricity build up in their machines while in use, especially on raster engraving operations. This build up of Static Electricity can become severe to the point that its discharge – via the 12v rail – can cause the motherboard to reset. Therefore causing interrupted engraving operations (Alarm 3/Connection Lost errors). In extreme cir…