Snapmaker not connecting correctly

[Chelsea (Chelsea McCauley)]

@berainlb

Move the laser head to 10, 30 so that the laser head is exactly position above the front-left corner.

Then issue in Console:

G92 X0 Y0

Check position. Does the position report as 0,0? If so, see if you can address the rest of the bed. It’s possible that Marlin will still refuse to allow you to go beyond the understood boundaries of the bed so the top may still be unaddressable.

I have done that - then i placed a piece of cardboard on the bed and told it to run. You can see in the pictures that the top part of the bed is still not useable.

@berainlb

If so, I don’t think you’ll have choice to but try to recompile the firmware with the proper dimensions and offsets.

I have no idea how to do this…