I ran a few more tests on our Vision, and couldn’t get Z-Steps per pass working.
The machine has a mind of its own and decides to randomly lift the Z-axis during the last pass without turning off the laser.
It then returns to the home position but Z remains at the current height.
The Z-Axis in Device Settings should be disabled until someone can find a workaround for this.
The Focus-Z function will still work when this is disabled. We only send the machine their custom command M130 and the firmware of the laser starts its focus sequence. That is: Move the head down until the material is detected, then move X & Y to the homing position. (The only way to prevent it from moving X Y after homing, is by using our “Focus Center” macro M130X200Y150.