Tracer lines during tracking

[scottsuydam]

I am seeing a line that follows the laser.

[Rick (Technical Evangelist)]

I will borrow from another, but this gets asked a lot.

Burn lines on laser path

Laser Burning Traversal Lines Traversal lines burning in my design Traversal lines still on and text in miror on woodite Burning between Shapes Laser not turning off when crossing white space

[scottsuydam]

I have the same problem and don’t know what to do.

[Rick (Technical Evangelist)]

@scottsuydam

don’t know what to do

???

Did you read the post I provided? In there, you will see a link to this exact solution:

Laser not turning off between cuts? (burning during travel moves)

If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …

Did you try this? What result did you get?