JohnJohn
May 10, 2022, 6:38pm
3
Welcome Gino,
I split your post from an old thread that wasn’t likely to get you the help and answers you’re looking for. I don’t have much to work with to assist here but we’ll need to make a distinction between Error 3 and Alarm 3 to begin.
Error 3:
We have a customer who is running 0.9.14 on an X Carve with a PC and is having an issue where the program will run, but then it will just stop in the middle and give an error 3 in the console and then it resets GRBL. Sometimes it gets through the whole project and then does this at the end and other times it does it in the middle. It doesn’t do this when carving in Easel, just in lightburn.
Thanks for the help in solving this mystery.
Jay
Alarm 3:
This could be a bad USB cable, static interference / electronic disruption, or failing or intermittent hardware issues.
You may also want to reach out to the nice folks at Ortur Support for additional troubleshooting procedures to validate their hardware is performing as expected.
Please screen-capture the error message you are seeing and some of the surrounding information so we can better assist you.
This may be worth review.
Folks,
When asking for support for LightBurn via this forum, email or anywhere else, please keep the following tips in mind for the fastest and most helpful answers.
controller does it have , and what firmware it is running?
Are you running the latest version of LightBurn?
Is the issue new, or has it happened before? What kind of computer is it, and what Operating System is it running?
system
June 9, 2022, 6:39pm
4
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.