LightBurn quits

Can anyone give me tips or suggestions on why during the middle of a print does Lightburn allows the laser to just quit or shuts off. Can I resume and if so how? Any help would be greatly appreciated. Thank you in advance.

This may be related: Ortur Laser Master 2 - Busy

You can resume by going to the Preview (Alt+P), sliding the slider to the spot where the job stopped, and clicking ‘Start here’ on the bottom. That will re-run the job from that point forward. As to why it’s stopping, there are a variety of reasons this could happen. Make sure the USB cable is secure on both ends, and that your computer is not set to allow USB port sleeping (sometimes called ‘Selective Suspend’).

These are general tips that may help:

Thank you for your assistance!!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.